This page is part of my Premium Base series of articles.
In the fifth stage of the Premium Base assembly, we will attach another Outer Frame and Light Frame.
These stages will be the nearly the same as the previous section.
Parts
Materials: The Outer Frame 3 is metal and the Light Panel 3 is plastic.
Build
Mark III Premium Base (5)
Stage 1 – Fitting the Light Panel
Step 1
Fit the Light Panel into the Outer Frame, aligning the four mounting tabs to their respective posts.
The raised center of the Light Frame sits down into the opening of the Outer Panel, as shown:
Step 2
Secure the Light Panel to the Outer Frame with four (4) HM screws.
These screws should not be over-tightened as they may crack the plastic of the Light Panel. This is also your friendly reminder to try using 3-in-One Oil on all screws going into metal:
Stage 2 – Fitting the Outer Segment
Steps 1-2
Retrieve your Top Cover assembly from the previous stage and turn it upside down. Fit this Outer Frame assembly to this edge location of the Top Cover and align the screw holes.
This Outer Frame should be fitted to the right of the previous Frame, as shown:
Steps 3-5
Secure the Outer Frame to the Top Cover with five (5) IM screws:
Thoughts
These stages are a bit repetitive, but at least we are halfway through attaching the Outer Frames!
Next Stage
Premium Base 6 – Outer Frame 4, Light Panel 4