Return to the BUILD

“In this issue, part of the interior structure of the lower right leg is assembled. This will be visible with the plates over this part of the armor are lifted.”

This issue will be very similar to the work we we did on the Left Inner Leg back in Issue 40 and Issue 41.



Materials: The Inner Support for the Calf is metal and the Inner Circuit Board for the Calf is plastic.


  • The History of Iron Man – Legacy of Doom: Knights in Shining Armor
  • Step by Step – Model Instructions
  • In the Comics – Out of Control: Who’s In Charge?
  • The Armor – Model-Prime Armor: An All-Purpose Tool


The Right Leg (2)

Stage 1 – Assembly of the Inner Circuit Board
Step 1

As with the previous left calf details, I used a mix of red, yellow, green, and blue Artistro acrylic paint pens, my Metallic Sharpies, and my Molotow Chrome Pen to ‘paint’ many of the details on this Inner Circuit Board before assembly:

Slide the narrow end of the Inner Circuit Board for the Calf through the ‘hoops’ of the Inner Support for the Calf, as shown.

Remember, at the narrow end of the Circuit Board there is a small hole that fits up onto a pin of the Inner Support:

Step 2

Secure the Circuit Board to the Inner Support from behind with two (2) IP screws:


It took a lot longer to paint the Circuit Board than it did to put it together!

Next Up

Issue 60 – Right Leg 3

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.