Return to the BUILD
“Assembly of the knee joint continues with the piece that will complete this important part of the Mark III armor.”
This issue will be very similar to the work we we did on the left knee back in Issue 31.
Contents
Parts
Materials: The Cover for Right Knee Joint is metal – the other parts are plastic.
Magazine
- The History of Iron Man – The Genesis of the Civil War
- Step by Step – Model Instructions
- In the Comics – A Trip to Washington: Spider-Man Between Two Sides
Build
The Right Knee Joint (3)
Stage 1 – Placing the Washers
Steps 1-2
Fit the holes in each Washer over these pairs of pins inside the Cover for Right Knee Joint, as shown:
Thoughts
Note that these Washers are not secured into place yet, so don’t lose them (or the unused Screw Cover) as we wait for the next issues. And while this was another super short issue, it also marks the halfway point in our Iron Man Mark III Armor build. We all have managed to get through over 270 parts and 170 screws just to reach this point, so take a moment to be proud of your accomplishment!
Next Up
Issue 51 – Right Knee Joint 4