ISSUE 35

Return to the BUILD


“In this issue, you will connect the lower left leg to the left foot, which was assembled in Issue 2. It is necessary to have this piece at hand.”

 

Contents


Parts

Materials: The Lower Left Leg is metal, but the remaining parts in this issue are plastic.

Magazine

  • The History of Iron Man – The Kang Dynasty: The Conquest of Earth
  • Step by Step – Model Instructions
  • In the Comics – The Super Group: The New Avengers
  • The Armor – Extremis: When Man is Not Enough

Build


The Left Ankle Joint

Stage 1

Retrieve your Left Foot assembly from Issue 2 and lift off the Upper piece that is held in place by the magnet:

Fit the two Ankle Washers on either side of the Lower Left Leg.

The notches in the Ankle Washers should be aligned to the notch in the Lower Left Leg, as shown:

While holding these Ankle Washers in place, slide the rounded end of this Lower Left Leg down into the bracket of the Ankle Joint.

The angled chunk of the Lower Left Leg should be facing forward, as shown:

Slide the keyed post of the Ankle Joint (35C in this issue) through the outside of the Ankle Joint on the Left Foot to align these parts together, as shown:

Stage 2

Fit the Ankle Lock Washer on the opposite side of the Left Foot Ankle Joint, aligning the notch as shown:

Secure the Left Ankle assembly together with one (1) MP screw from the outer side of the Foot:

Tighten this screw so the joint movement is quite stiff, but still allows you to rotate Lower Left Leg:

Fit the Upper plate back into place over the magnet of the Left Foot:

Thoughts


I am impressed that this ankle joint has both forward/back movement as well as a bit of side to side. It wasn’t easy to keep the Ankle Washers in place while completing this issue, but we made it through!

Next Up


Issue 36 – Left Thigh 2

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.