ISSUE 26

Return to the BUILD


“In this issue, the middle and ring fingers of the left hand are assembled, following the same procedure as the thumb and index finger.”

This issue will be similar to Issue 3, but only contains two more fingers of the Left Hand.

Contents


Parts

Materials: All of these parts are plastic.

Magazine

  • The History of Iron Man – Heroes Reborn: Back to the Beginning… Again
  • Step by Step – Model Instructions
  • In the Comics – Go West: West Coast Avengers
  • The Armor – Prometheus Armor: A Radical Change

Build


The Left Hand (2)

Here are the finger parts laid out in order. The top row is the middle finger (marked ‘3L’) and the bottom row is the ring finger (marked ‘4L’):

Stage 1

Identify the three parts marked ‘3L’ for the left Middle Finger. Fit the serrated tabs of each part into the matching slot of the next larger part. Secure the base knuckle to the middle section with one (1) FP screw:

Secure the fingertip to the middle section with one (1) CP screw:

Stage 2

Identify the three parts marked ‘4L’ for the left Ring Finger. Fit the serrated tabs of each part into the matching slot of the next larger part, as shown. Secure the base knuckle to the middle section with one (1) FP screw.

Note that the side we are installing the screws into has changed here:

Secure the fingertip to the middle section with one (1) CP screw.

As before, make sure you can fully ‘curl’ and extend each finger. If the screws are too tight, the joints will not be able to move:

Thoughts


This issue was basically just like the previous one and was completed very quickly. Keep these little finger parts stored safely for now.

Next Up


Issue 27 – Left Hand 3

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.